| <<Previous | Index | Next >> | ||
 |
 |
 |
||
| <<Previous | Index | Next >> | ||
| |
|
|
||
After you have attached the resistor between pins 2 & 3 make sure it is flush against the bottom of the PCB so that it does not interfere with the chassis. Now re-install the PCB into the chassis and carefully replace the 6 heatsink screws (temporarily only tighten them slightly), then replace the 4 PCB scres (fully tighten them), then fully tighten the 6 heatsink screws. The mod is now complete.
Created with Web Album Generator