Do the same thing for the output wires on
the LilliPCB (the wires furthest from the
LM2596). Solder the RED wire to Pin 1 of
J2 and the BLACK wire to Pin 2 of J2.
Your PSU should now look like this (except
for the charred PCB......don't ask...;).
Reassemble you unit by replacing the 4 bottom
screws (and lock washers) and the 2 heatsink
screw (and lock washers). Make sure they
are all snug. Now you're ready to put the
lid back on by carefully bending the new
wires in an "S" shape, replacing
the fan wire on its jumper, and gently placing
the lid on the chassis. Double check to make
sure there are no wires touching the fan
blade! Also make sure none of the wires are
pinched by lid, chassis, or LilliPCB.
Now you are ready to connect your USB hub
power connector to Pin 1 of J2 (white wire)!
Have fun, be careful, and enjoy!!
