Home| |
This was my attempt to add an external connector to my WUSB11. Unfortunately, I was not successful because I dropped the unit after I had finished soldering the connector on (and taking these pictures). It ripped the copper trace from the board. When I attempted to re-solder to the remnants of the copper trace I lifted the (very small) resistor and capacitor from the board. Since then I have been able to get a signal thru the unit, but the sensitivity and transmit power are terrible. I hope you have better luck.
 MVC756X.JPG 76.81 Kb 1024 x 768 |
 MVC757X.JPG 83.17 Kb 1024 x 768 |
 MVC951X.JPG 139.60 Kb 1024 x 768 |
 MVC952X.JPG 121.15 Kb 1024 x 768 |
 MVC953X.JPG 122.17 Kb 1024 x 768 |
 MVC955X.JPG 66.46 Kb 1024 x 768 |
 MVC957X1.JPG 133.46 Kb 1024 x 768 |
 MVC958Xs.JPG 109.04 Kb 480 x 360 |
 MVC961X.JPG 84.00 Kb 1024 x 768 |
 MVC963X1.JPG 74.29 Kb 1024 x 768 |
 MVC965X1.JPG 110.56 Kb 1024 x 768 |
 MVC966X1.JPG 113.34 Kb 1024 x 768 |
 MVC967X1.JPG 71.76 Kb 1024 x 768 |
 MVC968X1.JPG 99.85 Kb 1024 x 768 |
 MVC980X.JPG 99.60 Kb 1024 x 768 |